How to install the linkage on the rear axle of LDRC LD18401 RC car?

Begin by retrieving your replacement linkages. The pair designed for the LDRC LD18401 is the longest among the set of eight linkages.

Next, use a tool to clamp ldrc ld18401 shock double ball ends of the LDRC LD18401 mini rc car into the circular rings of the linkages.

Position LDRC LD18401 RC linkage to match the mounting holes on the rear axle. Insert a hex wrench to thread and tighten the shock screw into the axle hole. Hold the shock screw steady during tightening to avoid unwanted rotation.

Finally, you’re all done! The linkages for the LDRC LD18401 rc climbing car are installed successfully.

The stock linkage is made of plastic, so I recommend upgrading to a reinforced front axle assembly.

Buy: LDRC LD18401 Upgrade Parts Tie Rod