MJXHYPERGO Parts

Firstly, check if the servo control signal is stable and within the normal range.

Secondly, the servo’s gear precision and motor performance might affect its response speed. If the gears are worn out or the motor is not performing well, it could lead to delayed responses.

Lastly, make sure the servo is properly installed and not loose, as…[Read more]

The unstable signal of the remote control may be caused by obstacles interfering between the remote control and the vehicle or low battery power. Try to remove the obstacle and make sure there is no obstruction between the remote control and the vehicle.

Wheel slippage is usually due to a lack of tire grip. You can try adjusting the tire air pressure to keep it in the right range.

It may be caused by overheating of the motor, disconnection of the power line or ESC failure. Prolonged high load operation may cause the motor to overheat, which triggers the overheat protection mechanism to stop the motor from working. In addition, a poor or damaged connection of the power supply line may also cause the motor to disconnect.

The electrolyte inside the battery will gradually deplete and deteriorate over a long period of time, resulting in a decrease in the battery’s energy storage capacity.

In addition, the number of times the battery is charged and discharged will also affect its life, and frequent charging and discharging will accelerate the aging process of the battery.

First, batteries age with use and their ability to store power decreases.

Second, incorrect charging habits, such as overcharging or discharging, can also accelerate the aging process of a battery.

Yes, brushless differentials require special maintenance after extended use.

Maintenance includes cleaning the inside of the differential of dust and dirt, checking gears and bearings for wear, and replacing parts that are badly worn.

No, it may be caused by loose or damaged original parts inside the ESC.

Shorter battery life may be caused by battery aging and loss of capacity. Prolonged use or improper charging may accelerate battery aging.

If you think it consumes a lot of power, you can turn the lights off.

Overheating of the motor may result in damage to the motor, reduced performance or a shorter lifespan.

When installing the swing arm, make sure that the swing arm fits tightly with the frame, bearings and other parts to avoid loosening, which may lead to rattles and damages.

Also, pay attention to adjusting the angle of the swing arm to optimize vehicle handling.

If the shock absorber is damaged, the vehicle will bump violently when driving on uneven surfaces, which will affect the handling stability and driving experience, and may even lead to the damage of other parts.

Make sure the power supply is disconnected when repairing to avoid electric shock.
Use professional tools to avoid damaging other parts. You need to test it after repairing to make sure the function is normal.

If the RC car lags, delays or understeers when turning at high speeds, the servo may be underperforming and you need to consider upgrading to a higher torque and more accurate servo.

PVC material car shell is light weight, strong impact resistance, deformation easy to recover, commonly used in speed racing car.

Where is the best place to buy MJX Hyper Go 14303 RC Car?

First, check the servo’s connecting wires for loose or broken wires and make sure that both the signal and power wires are well connected.
Second, there may be a faulty motor or circuit board inside the servo, which usually requires professional repair or replacement of the servo.

Firstly, check whether the connection between the charger and the RC car is tight, as well as whether the USB port is clean and free of foreign objects.
Next, make sure the charging cable is intact, if the charging cable is damaged, you can replace it with a good quality charging cable for testing.

Rattling noises from the servo are usually caused by worn internal gears, damaged bearings, or insufficient lubrication.
Prolonged use or lack of maintenance may cause gears and bearings to wear out, increasing friction noise.
In addition, if the servo is installed in an improper position, such as under excessive pressure or vibration, it may…[Read more]